Opel of Frontera
+ Cars of mark Opel Frontera
- Current leaving and service
The routine maintenance schedule
Current leaving
The information on adjustment
Check of levels of liquids
Check of a condition of tyres and pressure in them
Replacement of impellent oil and the oil filter
Check of level of a liquid of system of hydrostrengthening of a wheel
Rotation of wheels
Check of a condition and replacement of hoses of an impellent compartment
Condition check, adjustment of a tension and replacement приводного a belt (only for engines with tension adjustment)
Check and adjustment of turns of idling of the engine and level WITH
Check of a condition of the battery, care it and gymnastics
Check and replacement of spark plugs
Check and replacement candle ВВ wires, a cover and бегунка the distributor
Check of level of oil in a manual box of a gear change and a distributing box
Check of level of a lubricant liquid of differential of forward and back bridges
Check of fuel system
Check of functioning of system of cooling
Check of a condition of system of release of the fulfilled gases
Check of a condition of components of a suspension bracket and steering
Check of a condition of protective covers of power shafts of forward wheels
Make check of brake system and replacement of a brake liquid with the subsequent prorolling
Check of a condition and replacement of brushes of screen wipers
Refuelling of a cooler of system of cooling
Replacement of the fuel filter
Replacement трансмиссионного oils РКПП and a distributing box
Replacement of a lubricant liquid of differential of forward and back bridges
Replacement of a distributive belt of the engine
+ The engine
+ Cooling and heating systems
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Manual box of a gear change
+ Kardannye shaft, the main transfer
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Controls and operation
+ Electric equipment schemes
|
Check of a condition and replacement of brushes of screen wipers
On brushes of screen wipers the road film in due course collects, reducing efficiency of their work, therefore brushes should be washed out regularly in a soft cleaning solution.
Check
| PERFORMANCE ORDER |
| 1. Assemblages of screen wipers with brushes should look round regularly. If survey has revealed presence of hardenings or cracks on rubber of brushes, replace brushes. If at survey it is not revealed anything unusual, wet a windscreen, include screen wipers, allow to them to work a little and switch off them. A non-uniform trace from brushes on glass or strips on pure glass specify that it is necessary to replace brushes. |
| 2. During work of the mechanism of screen wipers there can be an easing of fixing nuts, therefore they should be checked and necessarily to tighten each time at check of brushes (the Onboard electric equipment for more detailed information on work of the mechanism of screen wipers see the Head). |
|
Replacement of brushes of screen wipers
| PERFORMANCE ORDER |
| 1. Delay assemblage of a screen wiper with a brush from glass. |
|
|
2. Press a fixing uvula inside and remove assemblage of a brush from the screen wiper lever. |
| 3. If you wish to replace only rubber of brushes, disconnect the end of a brush from a brush framework, then pull out a brush from a framework. |
| 4. Compare a new brush with old on length, a design etc. |
| 5. Establish a new brush into place, then insert its end into a brush framework to fix it. |
| 6. Establish brush assemblage on the lever, then moisten glass and check up screen wiper work. |
|
|
|
