Opel Frontera

Since 1992 of release

Repair and car operation

Opel of Frontera
+ Cars of mark Opel Frontera
- Current leaving and service
   The routine maintenance schedule
   Current leaving
   The information on adjustment
   Check of levels of liquids
   Check of a condition of tyres and pressure in them
   Replacement of impellent oil and the oil filter
   Check of level of a liquid of system of hydrostrengthening of a wheel
   Rotation of wheels
   Check of a condition and replacement of hoses of an impellent compartment
   Condition check, adjustment of a tension and replacement приводного a belt (only for engines with tension adjustment)
   Check and adjustment of turns of idling of the engine and level WITH
   Check of a condition of the battery, care it and gymnastics
   Check and replacement of spark plugs
   Check and replacement candle ВВ wires, a cover and бегунка the distributor
   Check of level of oil in a manual box of a gear change and a distributing box
   Check of level of a lubricant liquid of differential of forward and back bridges
   Check of fuel system
   Check of functioning of system of cooling
   Check of a condition of system of release of the fulfilled gases
   Check of a condition of components of a suspension bracket and steering
   Check of a condition of protective covers of power shafts of forward wheels
   Make check of brake system and replacement of a brake liquid with the subsequent prorolling
   Check of a condition and replacement of brushes of screen wipers
   Refuelling of a cooler of system of cooling
   Replacement of the fuel filter
   Replacement трансмиссионного oils РКПП and a distributing box
   Replacement of a lubricant liquid of differential of forward and back bridges
   Replacement of a distributive belt of the engine
+ The engine
+ Cooling and heating systems
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Manual box of a gear change
+ Kardannye shaft, the main transfer
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Controls and operation
+ Electric equipment schemes

Check of a condition of components of a suspension bracket and steering

THE GENERAL DATA

The remark

Components of a steering drive and suspension bracket should be checked regularly. The worn out or damaged components of a suspension bracket and a steering drive can serve as the reason of excessive and dangerous deterioration of tyres, deterioration of running characteristics and controllability the car and to increase of the expense of fuel. For more detailed information on components of a suspension bracket and steering system address to the Head the Suspension bracket and a steering.

Check of shock-absorbers

PERFORMANCE ORDER

1. Park the car on an equal platform, switch off the engine and cock a lay brake. Check up pressure in tyres.
2. Press one of car corners, then release it, paying attention to body movement. It should cease to shake and rise in a starting position after one or two качков.
3. If the car continues to be shaken or has not come back in a starting position the possible reason of it is the worn out or weakened shock-absorber.
4. Repeat the procedure described above for each of three remained corners of the car.
5. Поддомкратьте the car and reliably establish it on support.
6. Examine shock-absorbers on presence of signs of leak of a hydraulic liquid. The easy film of a liquid is not at the bottom for anxiety. In case of leak detection make sure that the liquid follows from the shock-absorber, instead of whence still. If it nevertheless leak from the shock-absorber, replace shock-absorbers in steam on one axis (or all four).
7. Check up reliability of installation and integrity of shock-absorbers. Check up the top support on presence of damages and deterioration signs. In case of detection of those replace shock-absorbers.
8. In case of need replacements of shock-absorbers, address for instructions to the Head the Suspension bracket and a steering. Always replace both components on one axis, otherwise there can be a threat of safety of the car. If it is possible, try to replace all four components in the complete set.

Check of a condition of system of a steering and suspension bracket

PERFORMANCE ORDER

9. Examine components of system of a steering on presence of damages and deformations. Search for signs of leak of the liquid, the damaged linings, protective covers and штуцерные connections.
	10. Clear the bottom end of a rotary fist. Ask the assistant to grasp a bottom edge of a wheel and to shake it, and at this time observe of movement of the spherical support connecting a rotary fist with the lever. Examine protective covers of spherical support on presence of ruptures. If you find out люфт either it is necessary to replace the torn or proceeding protective covers, a spherical support (support).
11. Grasp each of forward wheels for forward and back edges and try to turn its first line inside, and back outside to check up presence люфта in a steering drive. If it is found out люфт, check up, whether ослабли fastenings of the steering mechanism and hinges of steering draughts. If ослабли fastenings, tighten them. If ослабли steering draughts the worn out hinges (check up at first reliability of a tightening of nuts) can be the reason. The additional information on system of a steering and a suspension bracket can be found in the Head the Suspension bracket and a steering.