Opel of Frontera
+ Cars of mark Opel Frontera
- Current leaving and service
The routine maintenance schedule
Current leaving
The information on adjustment
Check of levels of liquids
Check of a condition of tyres and pressure in them
Replacement of impellent oil and the oil filter
Check of level of a liquid of system of hydrostrengthening of a wheel
Rotation of wheels
Check of a condition and replacement of hoses of an impellent compartment
Condition check, adjustment of a tension and replacement приводного a belt (only for engines with tension adjustment)
Check and adjustment of turns of idling of the engine and level WITH
Check of a condition of the battery, care it and gymnastics
Check and replacement of spark plugs
Check and replacement candle ВВ wires, a cover and бегунка the distributor
Check of level of oil in a manual box of a gear change and a distributing box
Check of level of a lubricant liquid of differential of forward and back bridges
Check of fuel system
Check of functioning of system of cooling
Check of a condition of system of release of the fulfilled gases
Check of a condition of components of a suspension bracket and steering
Check of a condition of protective covers of power shafts of forward wheels
Make check of brake system and replacement of a brake liquid with the subsequent prorolling
Check of a condition and replacement of brushes of screen wipers
Refuelling of a cooler of system of cooling
Replacement of the fuel filter
Replacement трансмиссионного oils РКПП and a distributing box
Replacement of a lubricant liquid of differential of forward and back bridges
Replacement of a distributive belt of the engine
+ The engine
+ Cooling and heating systems
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Manual box of a gear change
+ Kardannye shaft, the main transfer
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Controls and operation
+ Electric equipment schemes
|
Check and adjustment of turns of idling of the engine and level WITH
The remark The engine should be heated-up to normal working temperature, with correctly established corner of an advancing of ignition and the adjusted backlashes of valves (there where they are regulated). The air filter should be in a good condition, and all electric components (including air central air where it is available) should be switched off.
| PERFORMANCE ORDER |
| 1. Connect a tachometre and a measuring instrument WITH to the engine. Mechanics use a special With-tester, which probe is established in the pipeline of system of release, but it is possible to use a usual tester which is inserted into an exhaust pipe. However pay attention that on models with каталитическим the converter of exhaust gases on an exhaust pipe it is impossible to receive correct indications of the maintenance WITH. |
| 2. To adjust manually idling turns it is impossible, as the stabilising pneumovalve of idling is put in action by the electronic block of management. If at normal working temperature of the engine idling turns do not correspond to the values specified in Specifications, check up system of a fence of air on presence of leaks, and also work of the stabilising pneumovalve (see the Power supply system and release). |
|
3. Verify indications of a measuring instrument WITH with the values resulted in Specifications. If adjustment is required, take заглушку from a measuring instrument of an air stream and turn the adjusting screw before reception of demanded value (on some models it can be demanded шестигранный a key). In summary establish new protective заглушку. |
|
|
Adjustment of level WITH on system Motronic. |
|
|
|
