Opel Frontera

Since 1992 of release

Repair and car operation

Opel of Frontera
+ Cars of mark Opel Frontera
+ Current leaving and service
- The engine
   Removal and engine OHC installation
   Removal and engine DOHC installation
   Engine dismantling
   Engine assemblage
   Head of cylinders and valves
   Pistons and rods
   The block of cylinders
   Cranked shaft and bearings of a cranked shaft
   Camshaft drive
   Engine mounts
   Compression check
   Greasing system
   Works with system of greasing of engine OHC/DOHC of 2.0 l
   Works with greasing system on the engine of 2.4 l
   The oil filter
   Oil radiator (if it is established)
   Pressure and oil temperature
+ Cooling and heating systems
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Manual box of a gear change
+ Kardannye shaft, the main transfer
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Controls and operation
+ Electric equipment schemes


Oil radiator (if it is established)


If on the engine the oil radiator it is under a forward part of the car is established. To reach an oil radiator, it is necessary to remove a lattice of a radiator of system of cooling.

1. Disconnect a cable of weight from the storage battery.
2. Remove a pallet guard картера.
3. Substitute capacity and merge oil, having turned out a stopper.
4. Remove a radiator lattice. The oil radiator is visible below.
5. Disconnect маслопроводы from a radiator and remove a radiator. Watch to damaging a radiator.

Installation of an oil radiator is made in sequence, to return its removal. Observe the inhaling moments.
After installation fill in in the engine the established quantity of impellent oil.