Opel Frontera

Since 1992 of release

Repair and car operation

Opel of Frontera
+ Cars of mark Opel Frontera
+ Current leaving and service
- The engine
   Removal and engine OHC installation
   Removal and engine DOHC installation
   Engine dismantling
   Engine assemblage
   Head of cylinders and valves
   Pistons and rods
   The block of cylinders
   Cranked shaft and bearings of a cranked shaft
   Camshaft drive
   Engine mounts
   Compression check
   Greasing system
   Works with system of greasing of engine OHC/DOHC of 2.0 l
   Works with greasing system on the engine of 2.4 l
   The oil filter
   Oil radiator (if it is established)
   Pressure and oil temperature
+ Cooling and heating systems
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Manual box of a gear change
+ Kardannye shaft, the main transfer
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Controls and operation
+ Electric equipment schemes

The oil filter

THE GENERAL DATA

The filter is in the bottom part of the oil pump. The filter represents a replaceable filtering element. The special key is applied to its removal. At filter installation oil a sealing ring and fix the filter so that to press a ring. In repair trucks the special key is applied to a filter inhaling with динамометрическим the control. The moment of an inhaling of the filter of 15 Nanometers.

Insert into a filter flute a new sealing ring, as is shown in иллюстр., having oiled it.
In the filter case is перепускной the valve. If necessary it can be replaced. The valve is under a stopper. To remove a stopper, it is necessary to drill an aperture and to cut carving М10. Screw bolt М10 and pull out a stopper flat-nose pliers.

The new valve запрессовывается оправкой in diameter 15 mm in an aperture against the stop.
After replacement of the oil filter check up in system oil level even if filter replacement was made in the course of oil replacement. Fill the engine with the established quantity of oil.