Opel of Frontera
+ Cars of mark Opel Frontera
+ Current leaving and service
+ The engine
+ Cooling and heating systems
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Manual box of a gear change
+ Kardannye shaft, the main transfer
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
Diagnostics of malfunctions of an onboard electric equipment
Safety locks
Fusible inserts (thermal relays)
Chain breakers (thermal relays)
The relay
Lighting devices
Removal and installation of a sound signal
Servomotor of adjustment of range of light
Screen wiper
Cleaner of back glass
Electric schemes
+ Controls and operation
+ Electric equipment schemes
|
Screen wiper
REMOVAL AND INSTALLATION OF LEVERS OF THE SCREEN WIPER
| PERFORMANCE ORDER |
| 1. Include and again switch off a screen wiper. |
| 2. Note position of a stop of both brushes on the tape pasted on a windshield to establish them in former position. |
| 3. Remove a cap of a support of a screen wiper. |
| 4. Turn away a nut being under it, remove a washer and the lever from a spindle. If necessary it is possible to take advantage of a small screw-driver. Watch to damaging a paint and varnish covering. |
|
The lever in sequence, by return to removal is established. After installation check up, that brushes have occupied the former position. On one lever it is established ветроотбойник.
REMOVAL AND INSTALLATION ПРИВОДНОГО OF THE ELECTRIC MOTOR AND DRAUGHTS
The electric motor
| PERFORMANCE ORDER |
| 1. Disconnect a cable of weight from the storage battery. |
| 2. Remove скобу fastenings of a tank of a cooling liquid and take out a tank. |
| 3. Remove screen wiper levers as it is described above. |
| 4. Remove a lattice from the air outlet channel to provide access to connecting bars of a screen wiper. |
| 5. Расстыкуйте штекерное electric motor connection. |
| 6. Turn away four bolts and remove the engine from an assembly frame. |
| 7. Cautiously insert a screw-driver under a crank and take out a finger of the spherical hinge |
|
Installation
| PERFORMANCE ORDER |
| 1. At installation connect the lever of a crank to the spherical hinge. |
| 2. Enter a crank through an air aperture and fix the electric motor four screws. |
| 3. In regular intervals tighten screws the moment of 9 Nanometers. |
| 4. Before installation of levers of a screen wiper quickly switch on and off a screen wiper drive. |
| 5. After that levers establish so that the size between the bottom edges of brushes and the bottom edge of a windscreen made 20 mm. |
|
Draughts of a screen wiper
| PERFORMANCE ORDER |
| 1. After removal of the electric motor of a screen wiper turn away five screws of fastening of a cover of the air channel and disconnect spherical hinges of levers of a screen wiper. Hinges fasten two nuts. |
| 2. Turn away five screws of fastening of draughts of a screen wiper and take out draughts and the hinge through an air aperture. |
| 3. Draughts can be disassembled. For this purpose remove draughts of spherical hinges. At assemblage watch that spherical hinges were fixed. |
| 4. If the crank acted in film from the electric motor, at installation it is necessary to check up correctness of its position. The fastening nut on an axis is tightened by the moment of 15 Nanometers. |
| 5. Draughts in sequence, by return to removal are established. Nuts of draughts tighten the moment of 9 Nanometers. |
|
|
|
