Opel Frontera

Since 1992 of release

Repair and car operation

Opel of Frontera
+ Cars of mark Opel Frontera
+ Current leaving and service
+ The engine
+ Cooling and heating systems
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Manual box of a gear change
+ Kardannye shaft, the main transfer
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Diagnostics of malfunctions of an onboard electric equipment
   Safety locks
   Fusible inserts (thermal relays)
   Chain breakers (thermal relays)
   The relay
   Lighting devices
   Removal and installation of a sound signal
   Servomotor of adjustment of range of light
   Screen wiper
   Cleaner of back glass
   Electric schemes
+ Controls and operation
+ Electric equipment schemes

Lighting devices

THE GENERAL DATA

Headlights Frontera provide distant and a passing light. Parking light lamps settle down in the case of the basic headlights.

REMOVAL AND INSTALLATION OF LAMPS НАКАЛИВАНИЯ OF HEADLIGHTS

PERFORMANCE ORDER

1. Open a cowl, wring out a spring latch from an underside of a headlight and uncover.

2. Расстыкуйте from a headlight underside the three-contact tip. Now the lamp накаливания, kept by a wire clip is visible.

3. Compress the clip ends, having removed it.

4. Take out a lamp, taking it for contacts.

5. Take a new lamp a pure napkin. It is not necessary to take a lamp hands, on a lamp there can be traces.

6. New двухнитевую a lamp insert so that its fixing nouse on a socle has entered into a groove of an aperture of a reflector. Thus average of three contacts should be in the top part of a socle of a lamp.

The further assemblage is carried out in sequence, return to removal. In summary it is necessary to check up adjustment of headlights (as a rule, it does not vary).

REMOVAL AND HEADLIGHT INSTALLATION

PERFORMANCE ORDER

1. In the presence of adjustment of range of light of headlights establish the adjustment switch in position "0" and after that switch off a headlight.
2. Remove a radiator lattice.
3. Расстыкуйте multicontact штекерное connection of a lamp of a headlight from the interior of an impellent compartment (preliminary having uncovered).
4. In the presence of adjustment of range of light of headlights remove the servo-driver as it is described more low.
	5. Turn away two bolts and take out a headlight from fastening in forward facing.

The headlight in sequence, by return to removal is established. Adjust headlight position.

HEADLIGHT ADJUSTMENT

Adjusting screws of a headlight are in the bottom part. Access to them is carried out through apertures in a radiator lattice. The arrangement of both adjusting screws is shown on an illustration.