Opel of Frontera
+ Cars of mark Opel Frontera
+ Current leaving and service
+ The engine
+ Cooling and heating systems
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Manual box of a gear change
- Kardannye shaft, the main transfer
+ Drive of forward wheels
- Drive of back wheels
Elimination of leakings of the back bridge
Removal and installation of semiaxes
Replacement of the bearing of a semiaxis
Removal and installation back карданного a shaft
Differential
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Controls and operation
+ Electric equipment schemes
|
Removal and installation back карданного a shaft
Integral карданный a shaft
Removal integral карданного a shaft is made similarly to removal forward карданного a shaft described in section Replacement of the bearing of a semiaxis. Difference consists that in this case on the one hand the shaft is taken out from шлицевого connections of a conducted shaft of a transmission. Oil following thus is necessary for collecting in appropriate way, having substituted capacity.
Compound карданный a shaft and an intermediate support
Here, as well as on integral to a shaft, fastening bolts self-stopped and the second time are not established.
| PERFORMANCE ORDER |
|
1. Mark with a paint mutual position of flanges карданного a shaft and a leading gear wheel of the main transfer on the back bridge. |
| 2. Turn on and beat out bolts. |
| 3. Turn away bolts of fastening of an intermediate support from a chassis cross-beam. |
| 4. Remove a support. |
| 5. Take out карданный a shaft from шлицевого connections of a conducted shaft of a transmission. |
| 6. For gathering of following oil substitute capacity. |
| 7. At installation карданного a shaft tighten its new bolts to a flange of a leading gear wheel of the main transfer, without tightening bolts. |
| 8. For an exception of wrong assemblage bolts of fastening of an intermediate support tighten at the car lowered on the earth. |
|
9. Bolts tighten the moment of 33 Nanometers. |
| 10. Now tighten fastening bolts фланцевого connections in regular intervals on a circle the moment of 75 Nanometers. |
| 11. In summary check up oil level in a transmission as it is described in corresponding section. |
|
REPLACEMENT OF THE INTERMEDIATE SUPPORT
| PERFORMANCE ORDER |
| 1. Turn away a bolt and remove a back plug with forward карданного a shaft. |
| 2. Remove a plug with шлицевого shaft connections |
|
3. Press an intermediate support. The arrangement of an intermediate support is shown on an illustration. |
| 4. At installation an intermediate support (2) напрессуйте on a shaft (1). |
| 5. Put on a back plug (3) a shaft. It is necessary to mean that the shaft has шлицевое the connection, allowing to combine details only in one position. |
| 6. Now карданный the shaft can be established on the car. |
|
Kardannyj shaft in gathering with an intermediate support
| |
1 - карданный a shaft
2 - an intermediate support
3 - a back plug |
Arrangement of a stain of contact in gearing of gear wheels of the main transfer (the left column - the party of a forward course, right - the backing party)
an and b - wrong contact, it is necessary to remove a leading gear wheel from conducted, having reduced a thickness of an adjusting washer,
c and d - wrong contact, it is necessary to move a leading gear wheel to conducted, having increased a thickness of an adjusting washer,
e - a correct arrangement of a stain of contact. |
|
|
