Opel Frontera

Since 1992 of release

Repair and car operation


Opel of Frontera
+ Cars of mark Opel Frontera
+ Current leaving and service
+ The engine
+ Cooling and heating systems
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Manual box of a gear change
- Kardannye shaft, the main transfer
   + Drive of forward wheels
   - Drive of back wheels
      Elimination of leakings of the back bridge
      Removal and installation of semiaxes
      Replacement of the bearing of a semiaxis
      Removal and installation back карданного a shaft
      Differential
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Controls and operation
+ Electric equipment schemes

8eee0de7

Replacement of the bearing of a semiaxis
THE GENERAL DATA

Drum-type brakes

For bearing replacement it is necessary to have a press.

PERFORMANCE ORDER
1. Clamp полуось in a vice.
2. Cut down a chisel a lock ring of the bearing. Use thus goggles.
3. Выпрессуйте an axis.
4. After that it is possible to remove a flange of fastening of the bearing and a brake board.
5. If the bolt of fastening of a brake board is replaced, it it is possible выпрессовать from a flange.
6. Insert a new bolt with gear cutting into a flange aperture.
7. After that completely it запрессуйте.
8. Establish on полуось a brake board and a lock plate.
9. Then establish the bearing and a lock ring.
10. Knot assemblage is shown on an illustration. It is necessary to pay attention to that the flute with a sealing ring on an external ring of the bearing looked aside шлицев axes.
11. Establish полуось as it is described above.
12. The epiploon is from the inside greased консистентной with greasing.
 
Semiaxis support at disk brakes (in the presence of ABS)
1 - a bridge sleeve
2 - the bearing case
3 - полуось
4 - a sealing ring
5 - the bearing
6 - ring ABS
7 - an epiploon

Disk brakes

PERFORMANCE ORDER
  1. The cut of knot of the bearing of a semiaxis in the presence of ABS is shown on иллюстр. On an illustration the additional epiploon established here is shown.
2. After semiaxis removal remove brake колодки (the corresponding section see).
3. Запрессуйте полуось through the bearing case.
4. If it is necessary, the bearing it is possible выпрессовать from the case.
5. Take out an epiploon (if it is) rings ABS from a bridge sleeve.
6. If it is necessary, выпрессуйте a bolt of fastening of a brake board from a semiaxis flange.
7. Establish in a bridge sleeve a new epiploon (if it is) for ring ABS.
8. At bearing replacement, it запрессовывается in the case.
9. The sealing ring of the bearing and a case aperture is preliminary greased. The ring should specify outside of a semiaxis.
10. Establish on a brake board the bearing case.
11. The bearing with the case and ring ABS establish on полуось and напрессуйте.
12. Now полуось it is possible to establish into place.