Opel Frontera

Since 1992 of release

Repair and car operation



Opel of Frontera
+ Cars of mark Opel Frontera
+ Current leaving and service
+ The engine
+ Cooling and heating systems
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Manual box of a gear change
- Kardannye shaft, the main transfer
   + Drive of forward wheels
   - Drive of back wheels
      Elimination of leakings of the back bridge
      Removal and installation of semiaxes
      Replacement of the bearing of a semiaxis
      Removal and installation back карданного a shaft
      Differential
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Controls and operation
+ Electric equipment schemes


8eee0de7

Removal and installation of semiaxes

Drum-type brakes

PERFORMANCE ORDER

1. Open a tank of a brake liquid.
2. Put on an aperture polyethylene
3. Again close a tank. It interferes вытеканию with a liquid at opening of brake system.
4. Turn out a bolt from a brake drum and remove a drum.
5. Disconnect a brake hose and a cable of a drive of a lay brake from an underside of a brake board. Work details are described in Chapter 9.
6. Turn away bolts and remove a brake board and a lock plate.
7. Take out полуось together with a brake board from the bridge.
9. Semiaxis installation is carried out in sequence, return to removal.
10. From an underside of a brake board the epiploon with which it is necessary to grease sits.
11. Fastening bolts in regular intervals tighten the moment of 95 Nanometers.
12. Establish the other removed details according to instructions.
13. Remove air from brake system.

Disk brakes

PERFORMANCE ORDER

1. Remove a support with directing, a washer, brake колодки.
2. Disconnect a cable of a drive of a lay brake as it is described in Head Kardannye shaft, the main transfer
3. The following work is carried out according to an illustration.
4. Turn out a bolt (1) and take out the gauge of angular speed ABS.
5. After that turn away four nuts (2) and take out полуось together with the case of the bearing and a brake board from a bridge sleeve.
6. Watch to damaging an epiploon in a bridge sleeve. The epiploon is shown on иллюстр. 6.2.
7. Carefully clear the interfaced surfaces of a sleeve of the bridge and the bearing case.

Semiaxis installation is carried out as follows:

PERFORMANCE ORDER
1. Insert полуось with the case of the bearing and a brake board into a bridge sleeve.
2. The interfaced surface of a sleeve or the bearing case is greased with hermetic.
3. Screw four nuts (2) shown on an illustration, with washers.
4. In regular intervals tighten the moment of 75 Nanometers.
5. Other works are carried out in sequence, return to removal.
6. Details of installation of details of a brake are described in Head Kardannye shaft, the main transfer.