Opel Frontera

Since 1992 of release

Repair and car operation



Opel of Frontera
+ Cars of mark Opel Frontera
+ Current leaving and service
+ The engine
+ Cooling and heating systems
+ The power supply system and release
+ Engine electric equipment
- Coupling
   Removal and coupling installation
   Coupling repair
   Coupling installation
   Check of coupling without removal
   The mechanism of deenergizing of coupling
   Removal of air from hydrosystem
   Adjustment of height and pedal free wheeling
+ Manual box of a gear change
+ Kardannye shaft, the main transfer
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Controls and operation
+ Electric equipment schemes



Coupling installation

THE GENERAL DATA

Coupling is established in sequence, to return its removal. Thus it is necessary to mean the following:

PERFORMANCE ORDER
1. At the removed coupling check up the needle bearing in a cranked shaft (for a manual transmission).
2. Insert скобы as it has been described above.
3. Establish on a flywheel a conducted disk according to marks "Getriebseite" - the transmission party.
4. If the coupling which was in the use is established, put it according to available marks. New coupling can be established in any position.
5. To centering of a conducted disk it is applied aligning оправка (1) (иллюстр.). Centering in the presence of experience can be executed approximately. It is possible to use an old primary shaft for this purpose. Remember that not all models have an identical transmission.
6. In regular intervals tighten cross-wise bolts of fastening of coupling. Bolts М7 tighten the moment of 15 Nanometers, М8 the moment of 28 Nanometers. Thus it is necessary to keep from проворачивания a flywheel. In certain cases screws "Torx" are applied to fastening. In the course of centering move forward and back оправку that it has not jammed.
7. After a coupling inhaling take out three скобы. Sometimes they fall out at a coupling inhaling. At loss скоб they can get in coupling. Watch that it does not happen.
8. Establish into place a transmission.