Opel Frontera

Since 1992 of release

Repair and car operation

Opel of Frontera
+ Cars of mark Opel Frontera
+ Current leaving and service
+ The engine
+ Cooling and heating systems
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Manual box of a gear change
+ Kardannye shaft, the main transfer
+ Brake system
- Suspension bracket and steering
   - Suspension bracket of forward wheels and the forward bridge
      Verifying and adjusting works on the car
      The works which are carried out with power shafts, блокираторами naves, naves and bearings of wheels
      Торсион, the shock-absorber and the stabilizer of cross-section stability
      Levers of rotary fists, rotary fists
      The forward bridge
   + Suspension bracket of back wheels and the back bridge
   + Steering with the hydraulic booster
+ Body
+ Onboard electric equipment
+ Controls and operation
+ Electric equipment schemes

Suspension bracket of forward wheels and the forward bridge

THE GENERAL DATA

Forward suspension bracket independent торсионная on dual levers. Contains hydraulic two-trumpet shock-absorbers, the stabilizer of cross-section stability. And торсионы adjustments of height of a road gleam.

From the middle of 1995 of release the design of a forward suspension bracket has been changed in view of introduction of antiblocking system. In this connection the design of the top and bottom cross-section levers has been changed also. Communication of the stabilizer of cross-section stability with cross-section levers is carried out now through connecting bars with spherical hinges. Changes have been brought in forward торсионы. Shock-absorbers газонаполненные. Cars from the middle of 1995 of release have the increased wheels in diameter of 16 inches instead of applied before wheels in diameter of 15 inches. The geometry of a forward suspension bracket has been accordingly changed.
Despite the made changes in a design of a forward suspension bracket of the car of 1997 of release the bridge has not been changed.

Before the description of the works spent on a forward suspension bracket, it is necessary to result some general instructions which are not mentioned further:
1 - Before removal of wheels it is necessary to mark their position concerning naves. At installation of wheels it is necessary to consider marks.
2 - All bolts, nuts and other fixture are necessary for tightening the established moment.
3 - Before the beginning of performance of any works it is necessary to disconnect a cable of weight from the storage battery.
4 - the Carving of the connections established on means for fixing "Loctite", before secondary application should проходиться леркой or a tap for removal of the rests "Loctite". It does not concern to микрокапсулированным to bolts.

PERFORMANCE ORDER

1. Before installation of a brake disk check up, that between a disk and a nave there was no dirt and extraneous particles. Interfaced surfaces should be equal and not have забоин.

2. Recycling of a brake liquid make according to the requirements established by the law.

3. Glues, hermetics, etc. Materials have certain working life. Do not apply the specified materials if their working life left.

4. After the repair termination the removed cables establish into place and fix the regular elements of fastening provided by a design of the car.

5. All works should be spent with observance of rules of a labour safety and environment protection. It is necessary to remember that the car has the big weight. It is not necessary to lay down under the car, without having accepted corresponding safety measures on car fastening in the lifted condition.

6. At отворачивании he is necessary for putting wheels nearby under the car, having provided with that additional security measures at car falling.