Opel Frontera

Since 1992 of release

Repair and car operation


Opel of Frontera
+ Cars of mark Opel Frontera
+ Current leaving and service
+ The engine
+ Cooling and heating systems
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Manual box of a gear change
- Kardannye shaft, the main transfer
   - Drive of forward wheels
      Removal and installation of power shafts of forward wheels
      Removal and installation of a nave of a forward wheel
      Forward карданный a shaft
   + Drive of back wheels
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Controls and operation
+ Electric equipment schemes

8eee0de7 Смотрите http://www.prostitutki-minska.org снять проститутку в минске.

Forward карданный a shaft
THE GENERAL DATA

REMOVAL AND INSTALLATION
The important remark
Fastening bolts карданного a shaft to a flange of the main transfer self-stopped and the second time are not applied.
PERFORMANCE ORDER
1. Establish a forward part of the car on supports.
2. Mark both flanges карданного a shaft in relation to the interfaced flanges, as shown.
3. Turn on and beat out fastening bolts карданного a shaft to flanges of the main transfer and a distributing box.
4. Remove карданный a shaft.

At installation the end of a shaft with a mobile plug should be connected to the forward bridge. Flanges incorporate according to marks. Bolts and nuts should be new. Tighten connection by hand. Further the inhaling is carried out as follows:

PERFORMANCE ORDER
1. Fastening bolts to a flange of the main transfer of cars of all executions tighten the moment of 75 Nanometers.
2. Fastening bolts to a flange of a distributing box at the petrol engine for the three-door car (transmission MSG) tighten the moment of 35 Nanometers.
3. Fastening bolts to a flange of a distributing box for the five-door car tighten the moment of 75 Nanometers.