Opel Frontera

Since 1992 of release

Repair and car operation

Opel of Frontera
+ Cars of mark Opel Frontera
+ Current leaving and service
+ The engine
+ Cooling and heating systems
+ The power supply system and release
- Engine electric equipment
   + Ignition system
   - Charge and start systems
      The storage battery
      The generator
      Starter
+ Coupling
+ Manual box of a gear change
+ Kardannye shaft, the main transfer
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Controls and operation
+ Electric equipment schemes

Starter

THE GENERAL DATA

The scheme of assemblage of starter Bosch

1 - a cover
2 - the plug
3 - the bearing case
4 - an excitation winding
5 - the case
6 - an anchor
7 - a plate щеткодержателей
8 - щеткодержатель

9 - a spring
10 - a back cover
11 - a coupling bolt
12 - the plug
13 - the drive lever
14 - a gear wheel
15 - a traction electromagnet

As it was specified above, the starter has compulsory moving of a gear wheel of a drive of the engine by means of the electromagnetic traction relay.
On the car firm Bosch starter, as a rule, is established. Starter Delco-Remy can be established also.

Starter check

Check up, whether the storage battery is charged and whether have окисной films connecting plugs of the battery. Especially it concerns the weight plug if it is not strong enough tightened.
To check up a starter at full pressure of the battery, it is necessary to connect plugs "30" (the big plug) and "50" (the small plug near to big) a cable to cross-section section a minimum 4.0 мм². If now the starter works faultlessly, it is necessary to check up wires to a starter. If the starter does not turn, it should be removed and checked up.
Exact check is carried out at the verifying stand or an electrotechnical workshop.

Removal and starter installation

Disconnect a cable of weight from the storage battery.

PERFORMANCE ORDER

1. Lift and establish a forward part of the car on supports.

2. Before a detachment of cables from a starter, it is necessary to remember an order of their connection. Disconnect a positive cable of the storage battery from the plug of a starter and further both cables from plugs 16 and 50. If disturbs, disconnect the bottom steel sheet.

3. Now it is possible to remove a starter. Its fastening can be various for various executions of the engine. Bolts can be inserted from outside the engine or a transmission. It is possible to apply also a basic arm.

4. Remove a starter, having developed it.

The starter in sequence, by return to removal is established. It is necessary to take into consideration the various moments of an inhaling. Fastening bolts from outside the engine tighten the moment of 45 Nanometers, a bolt from outside transmissions the moment of 75 Nanometers. The starter support (if it is available) is tightened by the moment of 25 Nanometers to the block of cylinders and the moment of 7 Nanometers to a starter.

Starter repair

If generator check shows that malfunction is available in the generator it is necessary to hand over it in repair in a specialised workshop. In the presence of experience it is possible to disassemble and collect a starter independently according to иллюстр.
Brushes of a starter as a result of long operation wear out and can be replaced independently. The back part of a starter (remove a small cover, turn out bolts and remove a collector) is for this purpose opened and brushes are taken out.