Opel Frontera

Since 1992 of release

Repair and car operation

Opel of Frontera
+ Cars of mark Opel Frontera
+ Current leaving and service
+ The engine
+ Cooling and heating systems
+ The power supply system and release
- Engine electric equipment
   - Ignition system
      Security measures at works with components of system of ignition
      System Bosch M1 5.4
      System Bosch M1 5.4 for engine DOHC
      System Bosch Motronic M1.5 of engines of 2.0 and 2.4 l
      Check of the moment of ignition
      Spark plugs - the general description
   + Charge and start systems
+ Coupling
+ Manual box of a gear change
+ Kardannye shaft, the main transfer
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Controls and operation
+ Electric equipment schemes

System Bosch Motronic M1.5 of engines of 2.0 and 2.4 l

THE GENERAL DATA

Below-mentioned instructions concern the engine of 2.0 l till 1995 of release and to the engine of 2.4 l

Removal and installation of the distributor of ignition

The distributor of ignition of the engine of 2.0 l to the middle of 1995 of release

Both engines have the distributor of ignition which is established as is shown in иллюстр. For the engine of 2.0 l. The distributor acts in film as follows:

PERFORMANCE ORDER

1. Turn away screws and uncover the distributor together with cables.

2. Now remove the distributor.

The distributor in sequence, by return to removal is established. Screws of fastening of a cover grease with means for carving fixing.
At the engine of 2.4 l the distributor acts in film and established as follows:

PERFORMANCE ORDER

1. Uncover, take out бегунок and protection against condensation water.

2. Turn the engine so that the distributor index looked at marks of the first cylinder on an external edge of the case of the distributor. For the control check up, whether the index looks at a control aperture on a flywheel ball.

3. Turn away fastening of a plate and take out the distributor from a cover of a drive of the mechanism of distribution.

4. At installation insert the distributor into the case of a drive of the mechanism of distribution and check up, that its index looked at a label of the first cylinder on an external edge of the case of the distributor.

5. Other works on installation are carried out in sequence, return to removal.

Removal and installation of the inductive pulse gauge

PERFORMANCE ORDER

1. The gauge is shown on иллюстр. (Engine OHC). Removal is carried out in the usual image. At the engine of 2.4 l расстыкуйте штекерное connection at a heater hose, having remembered its arrangement. Turn away a bolt on the case of the oil pump and take out the gauge.