Opel Frontera

Since 1992 of release

Repair and car operation


Opel of Frontera
+ Cars of mark Opel Frontera
+ Current leaving and service
+ The engine
+ Cooling and heating systems
+ The power supply system and release
- Engine electric equipment
   - Ignition system
      Security measures at works with components of system of ignition
      System Bosch M1 5.4
      System Bosch M1 5.4 for engine DOHC
      System Bosch Motronic M1.5 of engines of 2.0 and 2.4 l
      Check of the moment of ignition
      Spark plugs - the general description
   + Charge and start systems
+ Coupling
+ Manual box of a gear change
+ Kardannye shaft, the main transfer
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Controls and operation
+ Electric equipment schemes

8eee0de7

System Bosch M1 5.4 for engine DOHC
THE GENERAL DATA

Replacement of the module of ignition DIS

The block is from an underside of the engine near to a forward wall and can be found on four cables of ignition attached to it.
At removal of the block of ignition the ignition system should be disconnected.

PERFORMANCE ORDER
1. Turn away bolts and uncover ignition cables in the centre of a head of cylinders.
2. Расстыкуйте штекерное connection at the ignition module (behind at the left) also extend a cable.
3. Turn away four bolts (иллюстр.), крепящие the ignition module to an adapter.
4. Pay attention to how the module of ignition is established and take out it upward.
5. Installation of the module of ignition is carried out in sequence, to return its removal. Bolts of fastening of the block to an adapter tighten the moment of 8 Nanometers. Pay attention to a way of joining of cables of ignition (as is shown in иллюстр.). Cables have digital marks according to which they should be connected to the ignition module.

Replacement of gauge VMT of a cranked shaft

Replacement of the pulse gauge represents certain complexities for the person who does not have necessary experience as thus it is necessary to remove fixing скобы gates of injection and a rod electromagnet. Therefore it is recommended to execute gauge replacement in a repair truck. The gauge acts in film only at its replacement.

Replacement of the gauge of a detonation

Also as well as at replacement of gauge VMT of a cranked shaft this work represents certain complexities. If you consider that there are malfunctions in work of system of ignition owing to wrong functioning of the gauge of a detonation, it is necessary to address in a repair truck.