Opel Frontera

Since 1992 of release

Repair and car operation

Opel of Frontera
+ Cars of mark Opel Frontera
+ Current leaving and service
+ The engine
+ Cooling and heating systems
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Manual box of a gear change
+ Kardannye shaft, the main transfer
- Brake system
   Brake mechanisms of forward wheels
   The brake mechanism of back wheels
   Disk brakes of back wheels
   The main brake cylinder
   Removal of air from brake system
   The vacuum amplifier of a brake
   Lay brake
   Pressure regulator
   Brake hoses of forward and back brake mechanisms
   Antiblocking system (ABS)
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Controls and operation
+ Electric equipment schemes

Brake hoses of forward and back brake mechanisms

THE GENERAL DATA

Before replacement of any brake hose it is necessary to fill a tank with a brake liquid and as it is described in last subsection, to close its polyethylene. It will protect the basic part of a liquid from вытекания.

Forward brake hose

The hose on the one hand fastens to a support a hollow bolt (from two parties of angular connection sealing washers are established), and on the other hand it fastens to a square of a lock plate.

Removal

PERFORMANCE ORDER

1. For removal turn on накидную a pipeline nut.

2. The open end stop up for an exception of hit in a dirt.

3. Beat out a lock plate of fastening of a hose and disconnect it.

4. Remember the scheme of a lining of a hose and turn out a hollow bolt from a brake support. Pay attention to pin presence in connection. At assemblage it should enter into a support aperture.

5. Beat out the second spring stopper and remove a hose.

Installation

Installation of a brake hose is carried out in sequence, return to removal.

PERFORMANCE ORDER

1. Pay attention to correct installation of a pin.

2. A hollow bolt tighten the moment of 35 Nanometers.

3. The nakidnaja nut is tightened by the moment of 19 Nanometers.

4. Pay attention to accurate installation of spring clips of a hose.

5. Do not suppose hose twisting.

Back brake hose

Back brake hoses, as well as lobbies, fasten spring clips to a corner. Besides, they have additional болтовое fastening in a junction. At assemblage the bolt is tightened by the moment of 13 Nanometers, накидная a nut the moment of 16 Nanometers.