Subaru Legacy/Outback

1. Disconnect SRS (the Section System of additional safety (SRS) - the device and a functioning principle see).
2. Lower a steering column in extreme bottom position.
3. Disconnecting electroconducting, remove a forward cover of the central console and facing of the panel of switches.
4. Turn out fixing screws and remove the central (console) section of furnish of the panel of devices facing (peak) of an instrument guard.

5. Turn out fixing screws and remove a combination of devices, disconnect electroconducting.

1. Release a latch (F) and remove from a back cover () a casing ().
2. Release a latch (G) and remove from an internal casing glass of an instrument guard (), a reflector (D) and the window panel ().
3. Flat-nose pliers delay upwards clamps () in points () the printed-circuit board of a combination and through apertures (F), wring out outside of speedometer assemblage (D) and a tachometre ().
4. Delay upwards a clamp in the printed-circuit board centre () combinations of devices and remove from a casing (G) the printed-circuit board.

1. The design of a combination of devices of luminescent type is presented on an illustration.
2. Turn out the screw (), disunite contact sockets and remove an inverter (J) холоднокатодной a fluorescent lamp (CFL).
3. Liberate a plait (I) electroconducting CFL from a flute in a back cover, release a latch () and remove from a casing () protective glass (F), a reflector (G) and the window panel ().

4. Uncover a socket, having pulled for both edges, release clamps and disunite sockets of the flexible printed-circuit board of a combination of devices.

5. By means of nippers release clamps (N) on a back cover ().
6. Through apertures () push out outside of speedometer assemblage () and a tachometre (D)
7. Release the central clamp and remove the printed-circuit board from a casing.

1. Remove from a combination of devices assemblage of a speedometer with a measuring instrument of a stock of fuel (see above).

2. Measure resistance between plugs SIN (+)-SIN (-) and COS (+)-COS (-) a contact socket of a speedometer. If the result of measurement falls outside the limits a range 208 ± 8 Ohm, replace assemblage of a speedometer with a measuring instrument of a stock of fuel, otherwise a speedometer as it should be and it is necessary to replace the printed-circuit board of a combination of devices.

3. Installation is made upside-down.

1. Remove from a combination of devices assemblage of a tachometre with a measuring instrument of temperature of the engine (see above).
2. Check is made by analogy to speedometer check.
3. Installation is made upside-down.

1. Remove from a combination of devices assemblage of a speedometer with a measuring instrument of a stock of fuel (see above).
2. Installation is made upside-down.

1. Remove from a combination of devices assemblage of a tachometre with a measuring instrument of temperature of the engine (see above).
2. Measure resistance between plugs IGN-GND, IGN-UNIT and UNIT-GND a contact socket of a measuring instrument. Rating values make 208 ± 10 Ohm, 56 ± 10 Ohm and 264 ± 10 Ohm accordingly. At negative results of check replace a measuring instrument in gathering with a speedometer, otherwise replace the printed-circuit board.
3. Installation is made upside-down.

1. Open a cowl.
2. Disconnect a negative wire from the battery.

3. Disconnect electroconducting and remove the gauge of temperature of external air with bottom радиаторной panels.

4. Measure resistance between plugs of a contact socket of the gauge. If at temperature 25°С the result of measurement differs from value 1.7 clod, replace the gauge.