Subaru Legacy/Outback

1999-2003 of release

Repair and car operation


Subaru Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ The operation manual
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual box and differential
- Automatic transmission
   Specifications
   Electrohydraulic control system - the general information, appointment of basic elements
   Self-diagnostics system - the general information and functioning principles
   Diagnostics of general condition АТ
   Problem diagnostics АТ
   Removal and installation трансмиссионной assemblages
   Replacement of elements of a suspension bracket трансмиссионной assemblages
   Replacement of an epiploon of a casing of lengthening АТ
   Condition check, adjustment and replacement of the gauge-switch of the permission of start
   Removal and installation of the forward gauge of speed (VSS)
   Removal and installation of the back gauge of speed (VSS)
   Removal and installation of the gauge of turns of the turbine of the hydrotransformer
   Removal, service and installation клапанной assemblages
   Replacement of electromagnetic valves of switching, executive electromagnetic valves and the gauge of temperature ATF
   Filter ATF replacement
   Removal and installation of the module of management of transmission (TCM)
   Removal, installation and check of a condition of lines of a path of cooling ATF
   Removal, service and installation of components of the lever of selector AT
   Removal, installation, check of a condition and adjustment drive selector AT cable
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

8eee0de7


Replacement of elements of a suspension bracket трансмиссионной assemblages

The terminator of rocking of the power unit

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Remove an air cleaner/vozduhopriemnuju the chamber (see Has undressed Service of components of an inlet air path of the Head of the Power supply system and release).
3. Remove the rocking terminator (the Engine see the Head).
4. Make sure that the terminator bar not погнута and is not damaged. Estimate a condition резинометаллических plugs. In case of need make corresponding regenerative repair, or replace the terminator.
5. Installation is made upside-down, - track, that all fixture has been tightened with demanded effort.

Cross-section beam and rubber pillow of a support

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Поддомкратьте the car also establish it on props.
3. Remove reception, central and back sections of system of release of the fulfilled gases together with the muffler (see the Head of the Power supply system and release).
4. Uncover a thermofilter.
5. Prop up АТ special трансмиссионным a jack, - track, that persistent plates of transmission did not rest against the pallet.
6. Remove a back cross-section beam of transmission.
7. Remove a rubber pillow of a back support of a suspension bracket of the power unit.
8. Make sure that the cross-section beam not погнута and is not damaged, and also that the rubber pillow has not lost elasticity, has not cracked or by a different way it is not damaged. Make necessary regenerative repair, or replace the failed components.
9. Installation is made upside-down, - track, that all fixture has been tightened with demanded effort.