Subaru Legacy/Outback

1. Disconnect a negative wire from the battery.
2. Поддомкратьте the car also establish it on props.

3. Remove a filter of a fuel tank.

4. Disconnect electroconducting of the wheel gauge.

5. Release an intermediate clamp of fastening of a plait of electroconducting of the gauge on кузовном an element.

6. Turn out bolts of fastening of basic arms of a plait.

7. Remove gauge ABS from the suspension bracket lever, - do not pull the gauge for an electroconducting plait, try not to damage a polar tip.

8. For check of a condition of a rotor of the gauge which has been built in in шарнирную assemblage, remove a power shaft.

The description of procedures of check and adjustment of wheel gauges is resulted in Section Removal, installation and check of serviceability of functioning of forward wheel gauges ABS from that only a difference that the nominal size of a working backlash (S) makes for back gauges 0.44 ч 0.94 mm. Adjustment is made by lining selection № 26755АА000.

Installation is made in an order, the return to an order of dismantle of components. Track correctness of a lining and reliability of fixing of a plait of electroconducting (the left gauge - yellow isolation, right - white). All fixture should be tightened with demanded effort (Specifications and accompanying illustrations to subsection "Removal" see). Do not forget to adjust working backlashes by lining selection № 26755АА000.