|
1. Make a discharge of a central air in the conditions of a specialised workshop.
2. Disconnect a negative wire from the battery.
3. Remove an air inlet (see Has undressed Service of components of an inlet air path).
|
|
4. Disconnect from compressor assemblage hoses of high and low pressure.
|
|
Try not to lose sealing rings, at once after a detachment of hoses закупорьте their open ends approaching заглушками! |
|
|
|
5. Remove a basic arm of a radiator. |
|
|
6. Turn out two fixing bolts and accurately take the condenser from space between a radiator and the panel передка the car, - try not to damage ламели the heat exchanger.
|
|
If the condenser is subject to replacement, add in the compressor corresponding quantity of refrigerator oil (2 ml). |
|
7. Check up passableness of backlashes between ламелями the heat exchanger, in case of need clean their thin brush, or blow compressed air/wash out a water stream under a pressure, completely having removed particles of a dirt and remains of insects.
8. Examine the heat exchanger on presence of traces of leaks. In case of need make replacement.
|
|
9. Installation is made upside-down. Track, that bottom directing the compressor have got to reception apertures кузовной panels. Do not forget to replace sealing rings штуцерных sockets (before connection of hoses grease rings with compressor oil.
|
|
The central air recharge should be made in the conditions of a car-care centre workshop. |
|
|
