Subaru Legacy/Outback

1999-2003 of release

Repair and car operation



Subaru Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ The operation manual
+ Routine maintenance
- The engine
   Specifications
   Check компрессионного pressure in cylinders and tightness of the block
   Diagnostics of a condition of the engine with vacuum gauge application
   System of greasing of the engine - the general information
   + The procedures of the repair which has been not connected with extraction of the engine from the car, - four-cylinder engines
   - The procedures of the repair which has been not connected with extraction of the engine from the car, - six-cylinder engines
      Reduction of the piston of the first cylinder in position ВМТ
      Check and adjustment клапанных backlashes
      Removal and installation of a pulley of a cranked shaft
      Removal and installation of covers of drive ГРМ
      Removal and installation газораспределительных chains
      Removal and installation of asterisks of a drive of camshafts
      Removal and installation of an asterisk of a cranked shaft
      Automatic натяжитель газораспределительной chains - the general information
      Removal and installation of camshafts
      Removal and installation of heads of cylinders
      Removal and installation of the bottom section of the pallet картера and маслозаборника
      Removal, service and installation of the oil pump
      Service редукционного the valve of the oil pump
      Check of pressure of impellent oil
      Removal and installation of the gauge-switch of pressure of oil
      Removal and installation маслоохладителя
      Removal and installation drive a disk
      Replacement of support of a suspension bracket of the power unit
   + The general and major repairs of engines
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual box and differential
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


8eee0de7



Automatic натяжитель газораспределительной chains - the general information

Components automatic натяжителя газораспределительной chains

1 — the Case натяжителя
2 — the Spring
3 — Plunzher

4 — the Spring
5 — the Adjusting rod
6 — the Case плунжера


The design automatic натяжителя газораспределительной is shown a chain on an illustration.

Left and right приводные chains are equipped individual натяжителями. Натяжители hydraulic type use pressure of impellent oil and are capable to support automatically a tension drivers chains in the set range, excluding thereby requirement for manual adjustment.

In the case натяжителя there is an oil aperture which on established натяжителе is joined to a corresponding aperture in the block of cylinders. In the case натяжителя the chamber of a high pressure with a control ball is located. Pressure in the chamber is regulated редукционным by the valve. Thanking плунжеру with an external carving натяжитель it is capable to keep a tightness приводной chains at the set level even at the muffled engine.