Subaru Legacy/Outback

1999-2003 of release

Repair and car operation



Subaru Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ The operation manual
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
- Engine electric equipment
   Specifications
   Start of the engine from the auxiliary power supply
   Removal/installation, check and service of the storage battery
   Check of a condition and replacement of wires of the battery
   Ignition system - the general information and safety measures
   Check of serviceability of functioning of system of ignition
   Removal, installation and check of a condition of the module (it) of ignition
   Check and adjustment of installation of a corner of an advancing of ignition
   Replacement of gauges CKP, CMP and KS
   Service and replacement of spark plugs
   Check of a condition of high-voltage wires (4-cylinder engines)
   Charge system - the general information and safety measures
   Check of a condition of system of a charge
   The generator - the general information, check and service
   Removal, dismantling, assemblage and generator installation
   Start system - the general information and safety measures
   Check of serviceability of functioning of a starter and start chain
   Starter Nippondenso - check and service
   Starters Mitsubishi - check and service
+ Manual box and differential
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


8eee0de7



Start system - the general information and safety measures

System problem is проворачивание the engine for the purpose of realisation of its start. The basic components of system are assemblage of a starter with the traction relay (the magnetic actuator), the storage battery, the switch of ignition and connecting electroconducting.

 


For a complete set of models considered in the present Management starters Nippondenso or Mitsubishi are used. Assemblage of a starter with the traction relay is usually established in the top part of the power unit, near to a transmission dome.

At поворачивании the ignition key in position START the contour of management of system of start carries out food giving on the traction relay which makes switching of a food of the battery directly on the starter electromotor. The motor starts to rotate, simultaneously turning for a gear wreath planted on a cranked shaft of the engine a flywheel/privodnoj a disk.

On models with АТ in a chain of management starter functioning includes the special gauge-switch blocking start of the engine in positions of transmission, distinct from «Р» and «N». On models with Manual transmission engine start becomes possible only at the squeezed out coupling that is supervised by the gauge-switch of disconnection of a chain of a starter.

At performance of any works on service of components of system of start it is necessary to observe following special safety measures:

a) Remember that excessively long проворачивание the engine a starter can lead to serious damages of the electromotor of the last as a result of an overheat. Never use a starter continuously долее 15 seconds, - it is enough for cooling of the electromotor 1-2-минутной a pause;
b) do not forget that the starter is connected directly to the battery and casual handling of it is fraught fire-dangerous электродугообразованием;
c) performing any works with components of system of start, without fail disconnect a negative wire from the battery (remember that if the stereosystem established on the car is equipped by a security code before to disconnect the battery it is necessary to make sure of knowledge of a correct combination for audiosystem input in action).