Subaru Legacy/Outback

1. Поддомкратьте the car also establish it on props and remove back wheels.

2. On models Outback/Legacy the Versatile person release clamps and remove a carpet covering of a floor of a luggage space.

3. On models the Sedan remove a carpet covering of a floor of a luggage space and unbend the panel of lateral furnish from the corresponding party of the car.

4. Release a fixing nut and remove a bolt of fastening of the bottom support of the telescopic shock-absorber to the longitudinal lever of a back suspension bracket.

5. In a luggage space release nuts of fastening of the top support of the shock-absorber to кузовной panels.

6. Remove the shock-absorber.

1. The description of procedures of service of the shock-absorber see in corresponding subsections Has undressed Removal, service and installation of forward racks.

2. Before recycling of the failed shock-absorber it is necessary to extend against the stop outside its piston rod and to drill in a corresponding place of the case an aperture in diameter of 2-3 mm.

1. Prop up the shock-absorber a jack and tighten with demanded effort (30 Nanometers) NEW самоконтрящиеся nuts of fastening of its top support to кузовному to an element.
2. Having turned, get a regular automobile jack between the cross-section lever of a suspension bracket and a stretcher and adjust it so that apertures in the bottom support of the back shock-absorber were combined with reciprocal apertures in the cross-section lever.

In order to avoid stretcher damage enclose under a head of a jack rags.

3. A transmissionnym jack level the longitudinal lever horizontally and tighten with demanded effort (160 Nanometers) NEW самоконтрящуюся a nut of a bolt of fastening of the bottom support of the shock-absorber.
4. The further installation is made in an order, the return to an order of dismantle of components.
5. In summary drive away the car on a car repair shop for check and adjustment of corners of installation of back wheels.